Digital LED Panel Meter – Digital Electrical Measurement Instrument

The Digital LED Panel Meter is a panel-mounted measuring instrument that displays electrical measurement values in a clear digital format. Manufactured by Elmo Agencies, a manufacturer in Ambala, it is suitable for laboratory setups, electrical testing, educational applications, and equipment that require direct numerical reading.

A Digital LED Panel Meter uses an LED display to present measured electrical values as numerical readings. Unlike an analog panel meter that uses a pointer and graduated scale, the digital format allows the measured value to be read directly from the display.

SPECIFICATIONS OF DIGITAL LED PANEL METER

Maximum Input: 199.9mV DC
Maximum Display: 1999 counts (3-½ Digit) with automatic polarity indication
Indication Method: LED display
Measuring Method: Dual-Slope Integration A/Dconverter system
Over-range Indication: 1 shown in the display
Reading Rate Time: 2-3 readings per sec.
Input Impedance: Power Dissipation: 1mA
DC Decimal Point: Selectable with short-circuit
Supply Voltage: 8-12V AC or 5V DC

Please follow the instructions below for the operation of the Digital LED Panel Meter:

a. If necessary, add proper voltage dividers (RA & RB are not included) and a decimal point wire jumper according to the following table:

– For DC 200mV Range, use RA = 0Ω, RB = 10MΩ and connect to P3.

– For DC 2V Range, use RA = 10MΩ, RB = 1MΩ and connect to P1.

– For DC 20V Range, use RA = 10MΩ, RB = 100kΩ and connect to P2.

– For DC 200V Range, use RA = 10MΩ, RB = 10kΩ and connect to P3.

– For DC 500V Range, use RA = 10MΩ, RB = 1kΩ and connect to P1.

– For DC 2mA Range, use RA = 0Ω, RB = 100Ω and connect to P1.

– For DC 20mA Range, use RA = 0Ω, RB = 10Ω and connect to P2.

– For DC 200mA Range, use RA = 0Ω, RB = 1Ω and connect to P3.

– For DC 2A Range, use RA = 0Ω, RB = 0.1Ω and connect to P1.

Note that RA & RB are 1/4W 0.5% Metal Film Resistors.

b. Connect an 8-12V AC power supply to the panel meter.

c. For ranges other than 200mV, input an accurate 1/2 hMax voltage generated by a calibrator (e.g., 100.0 V for 200.0V range) and carefully adjust the semi-fixed resistor 201 to have the same reading on the LCD.

d. Connect the input DC voltage to be measured to IN+ and COM.

e. Connect the power to VCC+5V and VSS.

Key Features

• Clear LED numerical display
• Panel-mounted configuration
• Direct digital indication of measured values
• Easy-to-read display during practical work
• Suitable for laboratory and educational applications
• Useful for electrical testing and monitoring

Applications

The Digital LED Panel Meter can be used for:

• Electrical measurement and testing
• Physics and electronics laboratory experiments
• Educational demonstrations
• Equipment monitoring
• Electrical control and measurement panels
• Technical training

Ideal For

• Schools and colleges
• Physics and electronics laboratories
• Technical institutions
• Electrical testing setups
• Equipment and control panels
• Educational and practical demonstrations

Conclusion

The Digital LED Panel Meter by Elmo Agencies provides a straightforward way to view electrical measurement values through a numerical LED display. Its panel-mounted format makes it suitable for laboratory work, educational setups, electrical testing, and equipment monitoring.